Specifications
Packaging Type | Plastic Barrels, Drums Tanker |
Packaging Size | 0-5kg, 10-15 kg 15-20kg, 20-25kg and 50-100kg |
Grade | Technical Grade |
Specific Gravity | 1.38 |
Features | Longer Shelf Life |
Quality | Superior |
Additional Information
Product Code | EM03 |
PRIMEX – EPDM is a low viscosity solution of synthetic rubber and resins combined with organic, halogen free solvents. It is intended for use for the lap joint. Primex has been formulated with VOC exempt solvents for use in regulated markets where other solvent borne primers can not be used. This primer does not react with atmospheric moisture allowing it to be opened and resealed for use at a later date.
Application Procedure
PRIMEX is suitable for sealing the laps. All surfaces to be primed must be firm, flat, dry and free from dust and grease. PRIMEX is applied to the substrate with a brush or lambs wool roller. Laps should be at least 50mm and spread PRIMEX across the lap area. All work surfaces should be clean, dry, free of dirt, dust, debris,oils, un-adhered coatings, deteriorated membrane and othercontaminants that may result in a surface that is not sound or isuneven. If necessary, clean the surface with an approved EPDMor TPO membrane cleaner prior to application.
Coverage Rate
The coverage rate for PRIMEX is between 200g/m², dependant upon the evenness and porosity of the substrate and the type of application.
Important Imformation
Packaging
PRIMEX is packed in 4.5 kg tins/16 ltr pail.
Safety Precuations
Primex is a combustible material and should be shipped and stored away from open flames, heat or sources of ignition. Keep all pails tightly sealed while in storage. It should be used only in well-ventilated areas. It may cause eye, skin and respiratory irritation, and is harmful or fatal if swallowed. Avoid contact with skin. Use impervious clothing and rubber gloves to avoid prolonged or repeated contact with skin. Read the container label and follow all safety instructions.