DRYTEX P2000 high performance solvent free polyurethane based protective coating is designed to exceed the ever changing needs of both the industrial and commercial markets for seamless, hygienic and safe trafficable UV resistant roof waterproofing and protection coating. DRYTEX P2000 Heavy duty olyurethane Systems are Unique as they are specifically formulated to meet the demands of existing and new build fast track projects. It is One-component, heavyduty, exterior/interior, low-VOC, high-solids, polyester aliphatic urethane industrial floor coating. Provides a high gloss, UV stable ,excellent chemical resistance, color retention and chalk resistance . A range of resin rich floor systems that are moisture tolerant are ideally suited to the most aggressive environments, solvent free, non tainting and fully serviceable at temperatures up to 120° centigrade. DRYTEX P2000 is available in a range of standard systems in coloured finishes which include smooth, textured, terrazzo surfaces and antistatic grades.
High resistance to abrasion
High resistance to impact
Impermeability to liquids
Weather stability and colour fastness
Easy cleaning and care
DRYTEX P2000 was designed for use as wear resistant, waterproof membrane on vehicular and pedestrian traffic decks. DRYTEX P2000 is a durable abrasion resistant coating which waterproof and protects occupied spaces below, while isolating the substrate from the destructive forces of gasoline, oil, salts, solvents cleaning compounds and other chemicals commonly found in deck structures.
Surface Preparation All surfaces must be clean and free of any moisture, dirt, oil, grease, soapy films, surface chemicals, or other foreign contaminants .Surfaces shall be free of sharp projections, ridges and losses aggregate. The actual surface preparation procedures which are to be followed on a specific project will vary depending upon the age of the concrete, the degree of finishing or troweling, or presence of contaminants or curing compounds.
Coating Application Through mix DRYTEX P2000 prior to utilizing the material. Apply by brush, roller or airless spray and if required go for the second coat. Successive coats should be applied perpendicular to the previous coat to assure positive coverage and uniform film build. All surface must be uniformly coated and be free from voids, pinholes and blisters. Allow each separate coat of DRYTEX P2000 to dry tack free prior to Appling an additional coat. This will take a minimum of 4 hours.
Coverage Coverage rates will depend on the profile of the substrate. To obtain a 250micron thickness coat apply DRYTEX P2000 at a rate of 4 sq m per Litre. To obtain a 500 micron thickness coat apply DRYTEX P2000 at a rate of 2 sq m per Litre.
Packing and Shelf Life 5L and 20 L, If stored under covered roof , shelf life will be 18 months.
Safety Keep out of reach of children. Ensure to maintain good ventilation during application and drying process. In case of skin contact, wash with soap and water or a recognized skin cleaner. Avoid contact with eyes. In case of contact with eyes rinse immediately with running water and seek medical advice. If product is ingested drink plenty of water or milk. Do not induce vomiting at any time. Seek medical advice. Refer to the Material Safety Data Sheet (MSDS) for detailed information about the product and transportation and classification criteria.