D-FIX EPDM Waterproofing Membrane

D-FIX is a high strength bonding adhesive, specially formed to bond all types of materials. D-FIX is compatible with all types of insulation materials, structural and lightweight concrete, plywood, oriented strand board, wood fiberboard etc.

Features

• Excellent bonding ability and permanent adhesion
• Recommended for bonding of EPDM with variety of materials
• Easy application
• Resistant to water and moisture
• No mixing required
• Solvent-free and non-flammable
• Extreme adhesion for ultimate bonding
• Excellent heat temp ( +/_) resistant
• Highly Durable
• Odor-free
• Single-sided, wet lay-in adhesive
• Low VOC content (less than 50 g / litre )

Application Field
Can be used for variety of special applications including bonding to wood, concrete block, steel, paper and plastic.Bonding the membrane/protection boards to other various materials and to itself.Contact adhesive in construction and automotive industries

Coverage Rate
The coverage rate for PRIMEX is between 200g/m², dependant upon the evenness and porosity of the substrate and the type of application.

Application
Before application the surface should be clean, free of dust, moisture and grease. D-FIX isapplied to the substrate with a brush or roller.. EPDM Bonding Adhesive is installed in a onesided, wet lay-in application on horizontal surfaces. For vertical surfaces, the adhesive is used in the traditional two-sided application, and the two surfaces are mated only after the adhesive becomes tacky (approx. 10 - 15 minutes). This adhesive is a heat- and moisture-cure product, with the cure time depending upon ambient weather conditions. As such, this adhesive is to be used when the temperature is 40°F.

Packing
D-FIX is available in 18 L / 5 L metal pails.

Coverage
6 to 9 sqm/Ltr on an even surface depending upon the substrate material and type of application.

Storage
When stored in original, unopened container the average life is 10 to 14 months at 10 to 35 °Cif stored in above-mentioned conditions. Shelf life information is only a recommendation and not a fact of life. The real expiration date highly depends on the history of storage and handling of the accessories. Quality and applicability should thus always be verified: when mixed, product should stir into a smooth and homogeneous blend with no evidence of major clumping or separation/phasing. Once opened, use within 48 hours.

Safety
Keep away from naked fire. For any information. Do not smoke while applying. Do not usein a confined or unventilated area. Vapors are heavier than air and may travel along ground or may be moved by ventilation and ignited by pilot lights, other flames, sparks, heaters, smoking, electrical motors, static discharge, or other ignition sources at locationsdistant from material handling point and flashback. All containers should be grounded hen material is transferred from one container to another. A red caution label is requiredwhen shipping. A fire extinguisher should be available. In case of fire, use water spray, foam, dry chemical or carbon dioxide. Do not use a solid stream of water because it canscatter and spread the fire.ref. MSDS or consult with Safe@organixbs.com

Precautions
Refer to Material Safety Data Sheet. Flammable. Keep away from fire and open flame and other possible ignition sources during storage and use. Do not smoke when using. Use only in well ventilated areas. Avoid prolonged contact with skin. Do not contaminate withforeign materials. For professional use only. Keep out of reach of children. Thinning is notallowed. Avoid breathing vapors. Keep container closed when not in use. Use with adequate ventilation. If inhaled, remove to fresh air. If not breathing, perform artificial respiration. If breathing is difficult, give oxygen. Call a physician immediately. During application, efforts must be made to prevent fumes from entering the building via air ventilationducts. Do not place open containers or mix adhesive near fresh air intake units. When possible, shut down or seal off the closest units.